Fluid simulation
Introduction
Author: Aurélien RUMIANO
Patient: Mustafa Amid
Parameters of the study
Flow used for the fluid study 15l/min.
Inspiration phase.
Humidity and temperature are not taken into account.
🛑Disclaimer: I am neither a fluid mechanics researcher nor a doctor. The results I obtain using my fluid simulation software may be approximate. The purpose of these fluid simulations is to give you an idea of the air flow and possible problems related to it.
The illustration below represents the nasal cavity, the anterior part in red, the middle meatus in green and finally the inferior meatus in blue.
The following illustration represents the negative of the nasal cavity, that is to say the air which is inside the nasal cavity. All illustrations that follow will be represented in this manner.
The block that sticks the nostrils simply represents the air around it.

CT-SCAN



The lower turbinates are totally missing throughout the first 2/3 of the nasal cavity.
The septum is deviated, causing an obstruction on the left side (on the right in the image).
Airflow velocity







Description & analysis
The current lines represent the air flow, the speed scale goes from 0 to 2.5 m/s.
Speeds above 2.5 m/s are shown in red.
Wall Sheer Stress

Description
The areas colored red represent areas where the WSS is greater than 0.2 Pa. That is to say, these are the areas where the air rubs the most against the mucosa and therefore creates the most air sensation.
Airflow imbalance

XX% of the airflow passes through the right side and therefore XX% on the left.
So the airflow is not well balanced between the two sides. Enough to cause discomfort.
This is due to the obstruction at left on the anterior part.
Nasal resistance

Description and analysis
According to my little experience in fluid simulation, values between 10 and 20 Pa are normal.
Cross sectiona area

The data of the control group are pulled from a study, but I have seen some non ENS case at around 300mm². So I think that between 200 and 300 mm² the values can be considered normal.
Conclusion
...
| Situation | Mean cross-sectional area (mm²) | Mean mucosa perimeter (mm) | Mean WSS (Pa) | Pharynx size (mm²) |
|---|---|---|---|---|
| Actual | xx | xx | xx | xx |
| After virtual implants |
